DIY phone case

 

1. Cut off a sheet of baking paper Place your phone on it and cut around the phone with enough space so that the baking paper can comfortably cover the entire phone.
2. Tape baking paper to phone With the phone screen facing up, tape the baking paper around it. Make sure that the baking paper is taped only at the front of the phone.
3. Draw around phone buttons, charger dock and camera Use a pencil to draw around the camera, flash, power and volume...
4. Glue around phone edge Heat up the glue gun and draw around the bottom edge of the phone, which should facing down on  buttons and charging dock. You want no hot glue in these areas.

5.  Start the back of the phone case Once the edge is drawn, create the phone case design across the back of the phone. Get creative, but make sure that no glue gets in the areas that you drew in earlier, or else you won’t be able to access the camera, buttons, etc.

6. Let dry for 10 minutes and clean up case After the gluing is done, let the case sit for 10 minutes. Slowly remove the phone from the case and use scissors to cut off any excess glue.

7. 7. Use your phone case!